Overview of Getting Started with Gradescope and GauchoSpace
I. Make sure that your email address in UCSB Identity and in your GauchoSpace profile are the same.
A. Check Identity
B. Verify/Change in GauchoSpace
II. Log into Gradescope to create an account
A. Go to https://gradescope.com
B. Click on the “Log In” button in upper right
C. Click on the “University Credentials” button
D. Find the UCSB button near the bottom of the list
E. Enter your UCSB NetID and Password
III. Create a new course in Gradescope
A. Link the Gradescope course to your GauchoSpace site (if your email addresses don’t agree (see step I.), this will not work)
B. Synchronize the roster
IV. Create a new Assignment between both systems:
For each assignment in Gradescope, you need to create two objects in GauchoSpace for full integration. You need to add an “External Tool” as the link to let your students upload the assignment, and you need to create an “Assignment”, that does not allow submissions so that scores from Gradescope can be reported in GauchoSpace.
A. Add an External Tool to your GauchoSpace site as an upload link for the assignment. Label it appropriately.
B. Add an Assignment to your GauchoSpace site to report scores. Make sure it can not accept submissions.
C. Create a new assignment in Gradescope. Link it to the Assignment in GauchoSpace.
V. Workflow
A. Students will click on the link in GauchoSpace to engage the assignment in Gradescope.
B. You and your TAs will do all grading in Gradescope
C. When you click the “Publish” button after grading is complete, the scores will be pushed to GauchoSpace and will appear in the assignment and in the grade book
D. Rinse and repeat
VI. Detailed step by step instructions available HERE.